We first distributed this blog in November of 2014, but it has continued to be helpful and useful and wanted to share it with you again! Hazardous waste generators are under constant scrutiny to avoid violating regulations set by RCRA as well as national and state government. In order to help you avoid any potential violations we have developed the following list of 10 steps. If you manage your waste with these ten things in mind you should be able to maintain a safe and compliant workplace.
Containers of hazardous waste in a 90 or 180-day storage area must be marked with an accumulation date. Check that yours are each week during your inspection of the storage area. You could also consider using a log or spreadsheet to track wastes in addition to review of dates during your area inspections.
Remember, “Used oil is defined as any oil that was refined from crude oil or any synthetic oil, and that is used and as a result of such use is contaminated by physical or chemical impurities.” Any container holding used oil must be marked “Used Oil.” Additionally, pipes used to transfer used oil to a UST must be marked “Used Oil.”
Except in the instances of adding or removing waste containers should always remain closed. This means closing and latching funnels, screwing in bungs, using drum rings, and tightening bolts. Remember, if the contents would spill if the container was overturned, then the container is considered open.
Make sure you understand the regulations for universal wastes (things like batteries and used lamps). Properly label the wastes as “Universal Waste Batteries” and “Universal Waste Lamps.” Check your local state regulations as well.
Containers in a 90 or 180-day storage area must be marked with the words “Hazardous Waste” as well as listing: generator name and address, accumulation start date, contents, physical state, and hazardous properties.
Whether you’re a small quantity or large quantity generator, you must have a contingency plan in place. You can help make sure you avoid violations by designating an emergency coordinator, keeping information up to date and on-site, ensuring all required elements are included in your plan, and for LQG’s, document submittals to local authorities.
A hazardous waste reduction plan (often referred to as a waste minimization plan) is required for all hazardous waste generators. To keep yourself compliant make sure you keep a copy on-site, update that copy annually to ensure accuracy, make sure it’s signed by management, and ensure all applicable elements are included.
Utilizing satellite accumulation areas can be very beneficial to hazardous waste generators but it is imperative that all requirements listed in 40CFR are followed. Keep yourself violation free by reviewing and understanding the definition of a satellite accumulation area and by labeling your container once the first drop of hazardous waste is added.
Ensure consistency in your inspections by designating one day a week to perform them. Remember that Monday’s and Friday’s are not typically the best choices since they are often spent catching up from the weekend or readying for the weekend respectively. Have a back-up inspector and make sure that all inspections are documented in an inspection log.
You must make a hazardous waste determination for all wastes generated on your site. You should also make a list of each kind of hazardous waste generated. Determine if any exemptions apply to your wastes and figure out if your wastes are listed or characteristic hazardous wastes. Treat any unknown waste as hazardous until a determination has been made. Document everything and hold on to the documentation.
VP of Health and Safety Jim Mangas discusses the importance of plant safety, maintenance, and reliability (featured in BIC Magazine July/Aug '22)
Highlighting some of the wonderful interns we have at Heritage this year!
In this blog we walk you through the process of fuel blending, where we can turn hazardous waste materials into a viable alternative fuel source.
Our 12th annual Habitat for Humanity Build
On August 28th, 2021, the Louisiana coast was battered by Hurricane Ida. This included our Port Fourchon Service Center, where the devastating hurrica
Heritage Thermal Services is pleased to announce that its collection of household hazardous wastes for the East Liverpool area returns for 2022.
VP of Health and Safety Jim Mangas discusses preparedness for unexpected conditions during a project. (featured in BIC Magazine March/April '22)
Rachel McGrogan speaks about her time as a Lab Chemist at Heritage.